Latest GUI Version is 1.5. You can just do a "SW Update" on GUI to update to latest version

[vesion # just above footer image on GUI]

The Graphic User Interface (GUI) is NOT an APP. It is accessed thru a standard web browser on any device. Phone/PAD/PC/Laptop and start your favorite Internet Browser. Type 192.168.4.1 on the URL window. Make sure your wifi is connected to "Jackstreamer".

To access GUI on the browser:

- First connect your wifi to "JackStreamer" access point. Ignore if no internet connection. You are still connected to JackStreamer.

- Open a browser on the device and type 192.168.4.1 on the URL window

- You should have access to below GUI

- You can enable WiFi to Ethernet bridge (enable internet) but it is not recommended as use of device connected to JackStreamer for other App may have impact on audio traffic via JackStreamer 

Enable Internet

* Enable internet would setup a bridge between Wifi and Ethernet so you can use the same device to access GUI as well as browse/emai/zoom etc. However, we dont advise this as it will cause congestion on JackStreamer computer thus lowering the audio quality. Please do your zoom call or email etc on your laptop or PC etc.  You need to do ONLY one time. After OK, JackStreamer will setup the bridge and then reboot. Pls reconnect wifi after boot up.

Number of Channels

** Number of channels is to limit 1x1 or 2x2 (in&out) for JackStreamer session. This is ideal for low bandwidth home internet ( < 2 mbps uplink). Deafult is 2x2 (stereo). Please note that 1x1 will disconnect Right ch on both in (mic/line) and out (headphone). Preferably, all musicians on the session should switch to 1 ch mode so there are no missing channels.  Pls note that 1x1 do not mix ch1 and ch2 and sends as mono. This is only 1 ch input.

Auto Enable and Disable

This feature will enable auto start the JackStreamer to connect to Server automatically on Power bootup. It will use the last used session parameters to connect to the Server. You do not need to connect your device to JackStreamer WIFi and START session. If it does not autostart then you can do the normal way to start and stop session.

Please consider this that after your session, you need to POWER OFF (or thru GUI Stop session) the JackStreamer. If not, the connection would continue and your home bandwidth would be impacted. 

ideal operation of Auto Start feature would be: 

      - Power ON the JackStreamer when you are ready for the session

      - Power OFF as soon as the session is complete.